Problem with Enable pin turning low in middle of the run

7 views
Skip to first unread message

Filip Stojanovic Mechanical Engineering

unread,
Dec 8, 2023, 7:56:34 AM12/8/23
to Smoothie-Dev
Hi people,
I am having a lot of problems using Rearm with RAMPS 1.6+ and TMC5160 V1.3 drivers in Standalone mode. The problem occurs in middle of the run, Enable pin drops on a low logic level. and my steppers stop running. I have checked enable pin with oscilloscope and it drops to low logic level indeterministically, there are no rules. Sometimes it works for a few minutes and then shuts down, and sometimes it last longer or shorter. Can anyone help me?

Best Regards,
Filip Stojanovic

Wolfmanjm

unread,
Dec 8, 2023, 8:24:17 AM12/8/23
to Smoothie-Dev
there really is no information to go on here, so no one can really help you. if you were to provide a config, boot log, firmware version and some description of connections you may get some help.
Reply all
Reply to author
Forward
0 new messages