HP p2000 smis service

[Sri]

Hi All,

               Could any one please tell me that how to enable the smis service in HP p2000 ,

               It would be very helpful to me 

                Thanks in advance.......

--

Sri

[Mike Smith]

Hi Sri,

Use the 'set protocols' cli command to enable either 5989 (smis) or 5988 (unsecure smis).

To remove persistent data such as indication subscriptions, run the 'reset smis-configuration' cli command.

These same commands apply to the HP P2000 MSA G3 (FC/SAS/iSCSI/Hybrid) and the new HP MSA 2040 SAN.

There are 2 controllers and each controller has a cimom.  The data is the same from each cimom.

If you do not wish to use the default user (manage) then run the following cli command.

# create user interfaces wbi,cli,smis <myusername>

Thanks,

Mike Smith

Here are some sample commands and help information.
= = = = = = = = = = = == = =

# set protocols smis enabled usmis disabled

Success: Command completed successfully. (2012-01-21 14:4:55)

# help set protocols
...

smis enabled|disabled|on|off
 Optional. Enables or disables the secure Storage Management Initiative
 Specification (SMI-S) interface. This option allows SMI-S clients to
 communicate with each controller's embedded SMI-S provider via HTTPS port
 5989. HTTPS port 5989 and HTTP port 5988 cannot be enabled at the same time,
 so enabling this option will disable port 5988. This is enabled by default.

# reset smis-configuration a
 WARNING: The configuration of the SMIS service will be reset to default
 settings.  Any hosts registered via SMIS will need to be registered again.
 Are you sure? yes
 Info: SMIS service configuration has been reset for local controller.
 (2013-01-10 16:53:51)

 Success: Command completed successfully. (2013-01-10 16:53:51)

--
You received this message because you are subscribed to the Google Groups "SMI-S Developers Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to smi-s-developers-...@googlegroups.com.
To post to this group, send email to smi-s-devel...@googlegroups.com.
Visit this group at http://groups.google.com/group/smi-s-developers-group.
For more options, visit https://groups.google.com/groups/opt_out.
 
 

[Sri]

Very useful and helpful commands ,Thanks a lot 

To unsubscribe from this group and stop receiving emails from it, send an email to smi-s-developers-group+unsub...@googlegroups.com.