start and end files

[rapper]

Where are the start and end files stored that skeinfox uses? I am
trying to change the temperature, but no matter what I set the temp
to, my g-code files all have a start and end command to set the temp
to 240....?
thanks

[Jordan Miller]

Hi,

see discussion of start and end files here:
http://wiki.github.com/jmil/SkeinFox/

jordan

> --
> You received this message because you are subscribed to the Google Groups "SkeinFox" group.
> To post to this group, send email to skei...@googlegroups.com.
> To unsubscribe from this group, send email to skeinfox+u...@googlegroups.com.
> For more options, visit this group at http://groups.google.com/group/skeinfox?hl=en.
>

[rapper]

Ah yes, thanks for that. I forgot the original instructions.
However, I was trying to find the place where the current start and
end come from. There is no file already called
"start_SkeinFox_MakerBot_ABS.gcode". Must be embedded in code or
somesuch place.
thanks. (also thanks for writing great program!)

[Jordan Miller]

Oh, ya you will find that it's hard-coded in the "Preface" tool. You can change those file names to whatever you want, too.

jordan

[rapper]

Found 'em. Thanks, that works well.
Can I bug you with a new question? Do you have good control of the
ooze with your default settings in skeinfox? I am having a devil of a
time
and nothing I seem to do in oozebane decreases those strands.

[Jordan Miller]

start decreasing your temperature, 5 degrees at a time (but don't go too low, you will strip your filament). use the oozebane.stl file as a reference print file to test. also, turning on "comb" keeps the travel from jumping across open gaps inside a given volume. so that will help too.

attached are my current oozebane settings, if that helps too...

jordan