New Sprinter Firmware - 2011-09-09
35 views
Skip to first unread message
Joachim Glauche
Sep 9, 2011, 11:12:20 AM9/9/11
to Shapercube Support Group
Hi all,
I updated the firmware to newest Sprinter which solved some bugs.
Please check your Configuration.h for Shapercube specific options.
The firmware is available at:
https://github.com/Joaz/Sprinter
If you were using an older version of the Sprinter Firmware for
Shapercube, everything should just work.
If you were using the old Shapercube 0.6 firmware follow these steps:
- Re-connect Heater from D8 to D10
- If you are using a Heatbed, connect it to D8.
- Plug the Y endstop into Y-MAX (or Y+ depending on the RAMPS version)
Best Regards,
Joachim Glauche
I updated the firmware to newest Sprinter which solved some bugs.
Please check your Configuration.h for Shapercube specific options.
The firmware is available at:
https://github.com/Joaz/Sprinter
If you were using an older version of the Sprinter Firmware for
Shapercube, everything should just work.
If you were using the old Shapercube 0.6 firmware follow these steps:
- Re-connect Heater from D8 to D10
- If you are using a Heatbed, connect it to D8.
- Plug the Y endstop into Y-MAX (or Y+ depending on the RAMPS version)
Best Regards,
Joachim Glauche
Reply all
Reply to author
Forward
0 new messages