Y endstop

[Jens Galsgaard]

I can see where the Y endstop is supposed to go, but the switch doesn't activate before the extruder motor collides with the z motor.

Any ideas?

//Jens

[Jens Galsgaard]

Found a solution here: http://www.tkamsker.at/web/pub/shapercube-2.1rollenkugellager-umbau;jsessionid=414297546C3EE772215695C7CBB2AC37?p_p_id=54_INSTANCE_hpVb4mQ4IJA8&p_p_lifecycle=0&p_p_state=pop_up&p_p_mode=view&_54_INSTANCE_hpVb4mQ4IJA8_struts_action=%2Fwiki_display%2Fview&_54_INSTANCE_hpVb4mQ4IJA8_nodeName=Shapercube&_54_INSTANCE_hpVb4mQ4IJA8_title=Umbau+Y+Endstop

In case someone else tries to build this.

//Jens