You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Shapercube Support Group
Skeinforge works but I wanted to get up to speed with Slic3r. First
layer looks good but other layers are just junk.
I am not sure which G code flavor to use. I have tried all but "no
extrusion"
I have same problem on Slic3r 5 as well.
I have printed plenty of items on Pronterface successfully
I have the metal gear extruder. I asume I have the correct firmware
(I installed the metal gear extruder firmware in December) but I am
not sure how to check.