Shapercube 2.1 Steps_per_mm using 1/16 controller

22 views

Skip to first unread message

Stephen Horn

unread,

Jul 22, 2016, 3:30:17 PM7/22/16

to Shapercube Support Group

Hello,

I have been rebuilding all the electronic on a Shapercube 2.1 that was damaged in a lightening strike, nor have access to any of the original part lists has made this a lot harder than I expected. I have replaced the stepper driver units with 1/16 microstep driver and installed Marlin firmware. I have gotten everything to work, but I do not know the steps_per_mm. Can anyone tell me out with the steps_per_mm using 1/16 controller?

Reply all

Reply to author

Forward

0 new messages