Removing the strings from a 3D print

[charles meyer]

My talented lismtates,

Have you found any quick and easy way to remove those strings you get
once a print is done?

I printed a finger coral with tons of "cobweb-like" string between each finger.

By the time I'm done pulling each string off with a tweezer, the cows
will have come home and have finished their cud.

I tried the air can spray route and next will try electric razor brushes.

Thank you,

Charles.

[Farhan Ahmad]

Hello,

Can you share a picture for reference? Ideally, you wouldn't get much stringing if the printer is dialed in properly. It could also be due to wet filament.

- Farhan

--
You received this message because you are subscribed to the Google Groups "Sector67 Public" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sector67+u...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/sector67/CAFTwCBZ%3DvrK_YjbL2Rev%3DYJ2r-oc5_g7d5WUPoVpEeUM7Q2hsQ%40mail.gmail.com.

[charles meyer]

> To view this discussion visit https://groups.google.com/d/msgid/sector67/CAC8T1ObTKC9sLjkQFENLfAX_H-vNDbKojbR-CmA__guD5c451w%40mail.gmail.com.

[Jerry Miao]

Hair drier on low heat

---

From: sect...@googlegroups.com <sect...@googlegroups.com> on behalf of charles meyer <reachm...@gmail.com>
Sent: Wednesday, October 1, 2025 1:58 PM
To: sect...@googlegroups.com <sect...@googlegroups.com>
Subject: Re: [S67 Public] Removing the strings from a 3D print

 

To view this discussion visit https://groups.google.com/d/msgid/sector67/CAFTwCBZoqzYuMcRoTH6qTYr7FfBwdi%3DmDgVcKtyRsW8RMa2Z0w%40mail.gmail.com.