Two 'New QSO' method bug report

[aleksand...@gmail.com]

Hi,

1. If I leave New QSO 1 in Run (20m)

and go to New QSO 2 (15m) to start CQ there,

CQ starts in New QSO 1, not New QSO 2.

Changing the New QSO 1 status to S&P,

rectifies the situation and lets CQing in New QSO 2.

2. If I leave New QSO 2 in Run, go to Spot List 1 by clicking

    on a spot in there, and next press Enter to call that station,

    I call that station in New QSO 2 which is in another band.

To me, the two New QSO windows method needs

a lot of attention on the programming side yet.

Best regards,

Alec

[aleksand...@gmail.com]

Bug No.3

3. If leave NEW QSO 2 window in Run,

   while operating in the New QSO 1, 

   out of nowhere New QSO 2 starts CQing.

...

------ Wiadomość oryginalna ------

Nadawca "aleksand...@gmail.com" <aleksand...@gmail.com>

Do "SDC Software Defined Connectors" <sdc-...@googlegroups.com>

Data 19.05.2024 06:05:46

Temat Two 'New QSO' method bug report

[UT4LW Yuri Pavlov]

If you have enabled Auto mode in the New QSO 1 window, pressing F1 in any other New QSO window will start a CQ transmission in the New QSO 1 window. This is the standard protocol.
There are no other options.

воскресенье, 19 мая 2024 г. в 07:23:26 UTC+3, aleksand...@gmail.com:

[aleksand...@gmail.com]

Yuri,

no, it is NOT what is happening.

There is NO CQ-Auto mode enabled. 

I am running CQ in New QSO window No.1 while watching Spot List No.2.

At some moment, I hit <ESC> in window No.1 and switch over to New QSO No.2  <TAB>,

work two or three QSOs in New QSO window No.2, and suddenly I am switched back,

no F1 pressed, to the New QSO 1 and CQ starts from there on the previous band...

In such a case, logically, New QSO No.1 should NOT be allowed to TX,

while all the traffic is being performed in New QSO No.2.

Manual switching from Run to S&P in New QSO window No.1 secures that 

but it would be better if the TX prohibiting process in the previous New QSO window

had been invoked automatically...

It is a serious thing...

Best regards,

Alec

------ Wiadomość oryginalna ------

Nadawca "UT4LW Yuri Pavlov" <ur4ix....@gmail.com>

Do "SDC Software Defined Connectors" <sdc-...@googlegroups.com>

Data 19.05.2024 07:38:07

Temat Re: Two 'New QSO' method bug report

--
You received this message because you are subscribed to the Google Groups "SDC Software Defined Connectors" group.
To unsubscribe from this group and stop receiving emails from it, send an email to sdc-ut4lw+...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/sdc-ut4lw/fd0f9e1c-d195-4189-86c0-3bee517235ddn%40googlegroups.com.