SDC - CW Skimmer Frequency reading

[GianLuca Salvia]

Hello all,

I was trying to find the topic regarding this but did not succeed so far.

I will try to explain my issue in few lines:

SDC in cw skimmer tab

Radio: Flex tuned on 7,010,00

SDC : blue triangle with frequency reading at 7.010,00

SDC reads CW signal just 500 khz up

I enclose a picture, hoping that will help

SDC is set only on CW skimmer, no other functions.

Thanks so much in advance

GianLuca, IC8WIC

[UT4LW Yuri Pavlov]

Radio: Flex tuned on 7,010,00

SDC : blue triangle with frequency reading at 7.010,00

SDC reads CW signal just 500 khz up

I don't understand your question.The skimmer reads all signals in the IQ stream band (48-192 kHz). 

 

[GianLuca Salvia]

Hello again,

My bad in explaining...due to the poor skills...sorry about that.

Just to recap, 

I understand that the skimmer reads all signals,  what I am experiencing is that  the reading does not appear on the VFO A window on a tuned signal.

radio is tuned on 14,016,30

the blue triangle is correctly tuned on 14.016,30

I cannot read the transmission of the station on VFO A, 

As you can see from the attached picture , on the screen is 500HZ above (not khz as I wrote before  sri )
I hope i was able to explain myself a little better

have you all a nice weekend

73 de GianLuca

[UT4LW Yuri Pavlov]

Perhaps you entered "Offset for spot frequency"? It should be set to 0 for Flex.

воскресенье, 23 ноября 2025 г. в 13:37:39 UTC+2, ic8...@gmail.com:

[GianLuca Salvia]

I am afraid, offset is zero, I am keeping checking all parameters....

GianLuca