Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
Replacing a BNC input connector on a SR780 FFT analyzer.
33 views
Skip to first unread message
Jean-Pierre Coulon
Jan 4, 2017, 9:31:43 AM1/4/17
to
The big top lid is easy to remove. Then also the front panel and the disk
drive. Then I find a small shielded box with 6 BNCs.
It has a lid with 4 screws, the leftmost beeing blocked by the chassis.
Is the the right procedure?
Regards,
--
Jean-Pierre Coulon
drive. Then I find a small shielded box with 6 BNCs.
It has a lid with 4 screws, the leftmost beeing blocked by the chassis.
Is the the right procedure?
Regards,
--
Jean-Pierre Coulon
N_Cook
Jan 4, 2017, 11:12:40 AM1/4/17
to
flat spanner ?
JC
Jan 4, 2017, 12:36:31 PM1/4/17
to
www.thinksrs.com/downloads/PDFs/Manuals/SR780Servm.pdf
Jean-Pierre Coulon
Jan 6, 2017, 8:38:24 AM1/6/17
to
Finally I succeded after removing the 3 large boards and unscrewing the 6
screws at the bottom of the cavity. Aftewards there are screws at the borrom
of the analyzer and you can pull the mother board which has right-angle
soldered BNCs.
Bye,
--
Jean-Pierre Coulon
screws at the bottom of the cavity. Aftewards there are screws at the borrom
of the analyzer and you can pull the mother board which has right-angle
soldered BNCs.
Bye,
--
Jean-Pierre Coulon
0 new messages