I've tried paint remover - both citrus-based and the automotive stuff,
acetone, ligher fluid, even gasoline since I'd read that it dissolves
Shoe Goo. It seems to soften it some but it's got a lot of fumes and
doesn't really work all that effectively from what I've seen.
I'm re-doing some sneakers so I don't want to also dissolve the
sneaker material that the sole layer adheres to.
Thanks for all input.
Put gasolene in a covered pot, then put it on the stove on high for 38
minutes, goo will be gone.
> Put gasolene in a covered pot, then put it on the stove on high for 38
> minutes, goo will be gone.
Gee, thanks!
**SMACK** upside your head.
I don't know the exact ingeridents. But it's likely that nothing will
dissolve it once it's cured; I'd bet it's a superglue-type
polymerisation.
It might be a good idea to post the ingeridents if it says anywhere
- or does anyone else know?
Andrew Usher
Not sure it's cured and years ago when I used some, I seem to recall a
chlorinated solvent like tetrachloroethylene or ethylene dichloride.
Think you can buy paint removers with methylene chloride.
As a polymer it will take long time to dissolve or plasticize enough for
mechanical removal.
IIRC, the aroma of Shoe Goo reminded me of toluene. While not the
greatest substance to work with, there are many much worse. Next on my
list would be MEK, methyl ethyl ketone. That is more unpleasent.
Bill
--
Private Profit; Public Poop! Avoid collateral windfall!
did you call the 800 number on the side of the tube and ask them?
ransley wrote:
So will stove, kitchen, house...
IF any chemical will remove it, it would be important to know
composition of the item
it is being removed from. I did a google search on 'shoe goo msds" and
came up with
a link that provides an email addy to the co. for requesting MSDS:
http://www.eclecticproducts.com/SHOEGOODirections.htm
...and a link for technical data:
http://www.eclecticproducts.com/_tds/sg_tds.pdf
(uncured, remove w/acetone; cured, remove by cutting or scraping. "DO
NOT dry-clean Shoe GOO® because dry cleaning solvent breaks down the
cured adhesive.")
It's a silicone that polymerizes when exposed to the moisture in the
air. Chances are that anything you use to remove it will dissolve the
shoe and leave the Shoe Goo. Your best bet is a good sharp Xacto
knife.
Dangerous Bill
Geesh!, some people are so negative.
> IIRC, the aroma ofShoeGooreminded me of toluene. While not the
> greatest substance to work with, there are many much worse. Next on my
> list would be MEK, methyl ethyl ketone. That is more unpleasent.
Home Depot didn't have Toluene (I've also heard it'll rejuvenate dried
out magic markers) MEK definitely does the job. Nasty stuff though -
definitely outdoor use only. I've got the shoe set up outside on a
table, upside down - lay a cloth over the shoe bottom, pour the MEK
over the cloth holding my breath, then form a sheet of tinfoil over it
to impede evaporation. After a while it turns the Shoe Goo to mush,
which I scrape off with a folding knife, which seems to be the perfect
tool - use the flatter part of the blade to clean the broad areas and
curved depressions, the pointy part to get in the corners.
Thanks!