Questions about Arduino Fio angled male header

[Alan Wong]

Hi,

 

The male header posted at https://github.com/Safecast/bGeigieNanoKit/wiki/NANO-MANUAL looks different from my kit.  Please let me know if I have done it correctly as attached.  Just to make sure that the angled male header will not touch the main board below, am I correct?  Thank you very much.

 

Best regards,

Alan

[Planetary Paul]

Hi Alan, you did it correctly. Here is a picture of my BGN open, where you can just see the header on the Fio. The header shown in the manual is indeed a somewhat different type, but the position is the same.

Make sure the battery protection sheet doesn't get perforated as discussed here.