RoverGauge

Thanks for clearing that up. I did think that it seemed to be a lot of fault codes. :-) On Saturday,

Hi all - I've been using RoverGauge on a HP windows tablet for some time now (it's great BTW!

I have been running a 14CUX on a 3.5L; when I run the NA catalyst map (with O2 feedback) on the R3526

Hi My problem is, that RoverGauge won´t connect to Serial cable and I hope that someone in here will

Hello all, Have this marvellous bit of kit working but MAFpercentage = 0 and stay = 0. Assume this

Hi there, I have just ordered a USB-serial connector (using FTDI FT232R chip). My car is a 1992 Range

inside app in settings: Serial device name: Did you set the correct COM port?...... mine is COM4

I did find that if you install the tune resistor in the vacant plug, and install an EEPROM that

Hello I'm struggling to get it to work, I can't seem to install the 2 programs, and I am so

Success! It appears the signal ground must be tied to the ECM ground. if you connect the ground of

Hi, I am driving an MGR V8. The connector for the USB-Cable is very hidden. Therefore I want let the

OK, it's been a while, but I finally got back to looking at this today. The issue was the RX

I started using a different build environment somewhere in that interval (between 0.6.0 and 0.8.8). I

Not directly related to Rovergauge, but does anyone know if MIL circuit (ECU pin 10) is supposed to

Do the lambda odd/ even values have a direct correlation to sensor voltage? At idle in closed loop,

Hi. Recently purchased a cable and software from Blitz Racing. I also have an ECUMate, but RoverGauge

Hi, I am looking into making a Bluetooth cable, hard-wired into the diag socket on my discovery. The

I got a Dell Venue 8 Pro with Windows 10 installed. Will this app work?

All working thanks Once I figured out that I needed to be in the dialout group to be able to read the

I've also noticed several instances where with rovergauge connected, I will get a check engine