Simatic Net Pc Software V13 Sp1 Download

[Yazmín Bohon]

Hithere,

We have two SCADAs attatched to Ewon Flexy VPN and are trying to configure the system for us to do remote downloads.

When we connect to the system on the VPN we can access the machines and the shared folders where the SCADA software is kept. But in order to do the downloads we need to be able to be visible on Simatic Shell (we are using TIA V16 Proffesional). We are selecting the TAPV9 Connection to broadcast on but it shows an I.P of 10.29.6.4 but our LAN on the ecatcher is 140.80.50.XXX, how can we get this connection to work?

Apologies,

just to confirm we can get onto the network folder of the SCADA and see all shared folders.

But when it comes to doing a download of the TIA Portal project the error that comes up is the following

Hi both servers can be seen in the ecatcher vpn setup and we can ping/access network files.

The issue is something to do with Simatic Shell and how that communicates through the SCADA.

This is what is shown in Ecatcher when we remote in

But when we try and connect the Simatic Shell we cannot see the servers, and out I.P is not 140.80.50.xxx, instead it shows it as 10.26.6.4

image792575 23 KB

Hi Kevin,

after talking with Siemens we have managed to get the simatic shell software to work. The remedy was to add the PC we wanted to connect to as a multicast proxy as shown in the image bellow.

image603535 17.3 KB

Once this is done it allowed us to connect and download the file through TIA Portal.

Regards,

Vinny

3a8082e126