Troubleshooting SC114

[Andrew Pamment]

Hi

I built Steve's SC114 today, but I've done something wrong.

I have no modules plugged in, but when I press reset, the LED flashes off just once like it thinks there is a serial board attached.

I get no output / input on the 9600 port, but the led stays on like it's working.

I tried plugging in my serial board from my RC2014, but again it flashes off once and no output/input.

I've checked all the ICs and they all seem to be in properly, my soldering seems to look ok.

Anyone have any ideas on how I might narrow down the problem and figure it out?

Thanks,

Andrew

[Andrew Pamment]

Of course the minute I write this I figure it out.... it was a solder joint on the address line of the eprom :/

All working now :D