Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

Dremel Mod 580 Table Saw

1 view
Skip to first unread message

ronald hargreaves

unread,
Apr 18, 1998, 3:00:00 AM4/18/98
to

I`ve just been given this tool and it does not have the Rip Fence
or Miter Feed attchment. Called Dremel and was told the tool is no
longer in production and parts are notavailable.
Does anyone have these parts that they would be willing to sell?

Ron Hargreaves Apr 18



Sp400racer

unread,
Apr 18, 1998, 3:00:00 AM4/18/98
to

> I`ve just been given this tool and it does not have the Rip Fence
>or Miter Feed attchment.

Call Micro Mark at 1-800-225-1066 They have accessories and blades for the
Dremel Table saw. Better quality than the original, but higher prices.

Azarr

Larry Smith

unread,
Apr 19, 1998, 3:00:00 AM4/19/98
to

ronald hargreaves wrote:
>
> I`ve just been given this tool and it does not have the Rip Fence
> or Miter Feed attchment. Called Dremel and was told the tool is no
> longer in production and parts are notavailable.
> Does anyone have these parts that they would be willing to sell?
>
> Ron Hargreaves Apr 18
>
Ron the best tool for this saw is one you can make yourself.

It's a cutoff box that uses the saw's miter slots.

I'll attempt a drawing:
||
side view: ||____________||
--------------
______________
front view: | |
|______________|
" "
______________
top view: |______________|
| |
| |
| |
|______________|
|______________|

I know the drawing leaves a lot to be desired, so a short discription,
use aprox 10"x8"x3/16" ply floor with a 1"x2" pine back fence and a
1"x1.25" front fence, attach runners on the bottom that fit the saws two
miter slots.
To use, put the box in the miter slots and run it over the blade,
cutting a kerf in the front fence, through the 3/16" bottom and in the
back fence. Any questions that I can help with, send an e mail.

Larry Smith


Charlie Reich

unread,
Apr 19, 1998, 3:00:00 AM4/19/98
to

In article <353A2E...@vegas.infi.net>, lds...@vegas.infi.net wrote:

ronald hargreaves wrote:

I`ve just been given this tool and it does not have the Rip Fence
or Miter Feed attchment. Called Dremel and was told the tool is no
longer in production and parts are not available.
Does anyone have these parts that they would be willing to sell?

Ron Hargreaves Apr 18


Ron,

Parts : Blade, rip fence, drive belt etc. are currently available from

Micro Mark
The Small Tool Specialists
340 Snyder Avenue
Berkeley ?Heights, NJ 07922-1595
1-800-226-1066
<www.micromark.com>

Be sure and order their "Killer" full color catalog.

Charlie Reich
The Society of Antique Modelers

ronald hargreaves

unread,
Apr 19, 1998, 3:00:00 AM4/19/98
to

Thanks for te info

Ron



ronald hargreaves

unread,
Apr 19, 1998, 3:00:00 AM4/19/98
to

Thanks for the info.

Ron



0 new messages