Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
TECH: GO5 no glow
0 views
Skip to first unread message
Tenn_pin
Nov 21, 2009, 10:50:27 PM11/21/09
to
I have this Asteroids playing blind. The F100 was blown, so I replaced
it and it did not blow again, but still no HV or glow. I plan on
putting a cap kit in it, I just want to know what else I need to order
from BR. Does anyone have a flow chart?
it and it did not blow again, but still no HV or glow. I plan on
putting a cap kit in it, I just want to know what else I need to order
from BR. Does anyone have a flow chart?
Thanks,
R
z28...@hotmail.com
Nov 23, 2009, 12:51:20 PM11/23/09
to
There are two white, large ceramic resistors that go open on these,
check the resistance with a multimeter and read the resistance.
I Believe they are numbered r100 and r101, they should be replaced
with a jumper wire.
Also, these boards are notorius for cold solder joints, mainly the
connector pins.
check the resistance with a multimeter and read the resistance.
I Believe they are numbered r100 and r101, they should be replaced
with a jumper wire.
Also, these boards are notorius for cold solder joints, mainly the
connector pins.
Tenn_pin
Nov 28, 2009, 6:48:17 PM11/28/09
to
Cold solder joint it was. Between the resistor and pin that goes back
to the 2nd fuse in the bottom of the cabinet. Thanks for the reply.
to the 2nd fuse in the bottom of the cabinet. Thanks for the reply.
R
0 new messages