Obviously if they are passive there shouldn't be a problem, but I see
the term "active antenna" used and I'm wondering...
Kirk
Indeed, placing two GPS receivers in close proximity to each other can
cause problems, due to radio frequency interference emitted by the GPS
receivers themselves. I've seen this most acutely with receivers from
two different manufacturers, place them within a few inches of each
other, and one or both will lose satellite lock in short order. I'd
keep the receivers separated by a least a foot or so (the GPS 35
receiver is, of course, inside the "antenna"). Placing the two antennas
in close proximity should be less of a problem, though I suppose RFI
from one receiver could in some cases leak into the other by way of the
antennas...
Marc
I had a problem in my glider with a Garmin 12XL and my LX4000. The antenna
from the LX was mounted on a metal panel cover which when the canopy was
closed caused the loss of both signals to the GPSs. Had to fit a plastic
cover to cure this. The 12 XL is about 12 ins from the antenna of the
LX4000.
Peter.
As a data point, I am running a Cambridge 25 and a 302. The GPS
receivers are apporximately 8 inches apart their remote antennas about
10 inches apart.
I've seen no problems with any of my traces, nor have I lost signal
long enough to generate a message on my SN10.
OC
<fiveni...@yahoo.com> wrote in message
news:1120172320....@g14g2000cwa.googlegroups.com...
Bob
Thanks everybody for the feedback & info; I'll have to make sure that I
test my installation thoroughly before flight. Which is a good idea
anyway!
Kirk
I've had problems with two GPS receivers near each other. My problem was
with a Garmin 12XL which wouldn't work on the dash of a specific car. I
eventually realised that the car was fitted with it's own GPS receiver under
the dash.
> Obviously if they are passive there shouldn't be a problem, but I see
> the term "active antenna" used and I'm wondering...
It's not just active antennas that will influence each other. I don't know
much about the technical stuff so can't offer a proper explanation, but
you've only got to look at a yagi type antenna (for example a TV antenna) to
see that mounting antenna near each other has an impact. Basically each
element in the antenna is an antenna in it's own right which receives and
re-radiates the signal. In a Yagi the purpose is to increase the
directional gain, but unintentional coupling of antennas is likely to have a
detrimental effect.
Stephen
Herb, J7
I play with GPS for a living at Boeing, and you shouldn't see any
issues. Active antenna simply means there is an amplifier in the
antenna that boosts the output of the antenna, overcoming cable losses.
I'm trying to decide what sort of flight computer to buy - I'm ready to
discontinue the use of my L-Nav and GPS Nav. Any opinions?
Regards
Mark H.