Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss

90,000 mile inspection on a 2001 GC

4 views
Skip to first unread message

Larry

unread,
Jan 5, 2013, 11:44:49 AM1/5/13
to
Just had a 90,000 mile inspection on my 2001 GC. Everything checked
out OK, but what really pleasantly surprised me was the brakes still
had over 80% of brake pad remaining. In the past only the front brake
pads were replaced at 30,000 miles because of the warped rotor
problem. So at 90,000 miles I was expecting to at least replace the
brake pads.

I bought the car new and have never replaced the brake fluid. The
mechanic said the brake fluid was good for about 100,000 miles.

Any conventional wisdom on when to change the brake fluid?

Thanks,

Larry

DougW

unread,
Jan 5, 2013, 12:16:02 PM1/5/13
to
Moisture intrusion eventually kills brake fluid.

Fairly easy to bleed the brakes, usually done when replacing pads.
Basically, rather than pushing the fluid back up when compressing
the piston, you just put a little hose on the bleeder and squeeze
the fluid out into a jar. Then tighten the bleeder and add fluid
to the reservoir as required.

I've also just suction out the fluid in the reservoir and
replaced with fresh fluid. It cycles a bit, but not much.
My reasoning is any moisture intrusion is from the reservoir.

That leaves the lines. About every four years I suction out
a few oz of fluid from the system and add fresh.

The suction gun is a great alternative to having someone
push the pedal down for you. Just make sure the reservoir
doesn't run dry.

--
DougW


Larry

unread,
Jan 5, 2013, 8:03:57 PM1/5/13
to
On Jan 5, 10:16 am, "DougW" <I.only.read.use...@invalid.address>
wrote:
Thanks for that info!

0 new messages