rLab / Reading's Hackspace

78cm is the table top width, between the table legs is 76.5cm / 26.5", as this is the largest

Hi Folks, TLDR; Electronics Evening in the lab tomorrow (Tuesday 28 Jun) - very informal, turn up if/

Sorry for the late response, my email browser bricked for some reason :/ No thank you there were a

Many thanks. Sounds perfect. I will investigate next week. On Sat, 25 Jun 2022, 17:47 Frank in

Sounds like a very good idea, the radio clock receiver thing. I had no idea they were so cheap /

This might work or at least give some ideas. https://www.thingiverse.com/thing:4531625 Sent via

Please could you reply direct off list Hugh [alex alexgibson net], and we can sort time/location

Hi all, just to let you know that I'm hoping to do quite a lot of cutting on the laser this

Richard, Thanks, that's really useful! So much so that I have started a Wiki page to capture

We should ask this guy. If only anyone knew who he was or where he lived ;). EL560 On Wed, 15 Jun

That would be great, thanks, Ed On Monday, June 13, 2022 at 3:44:53 PM UTC+1 di...@rlab.org.uk wrote:

Hi Gerald, Thank you for continuing to respond. It really has had me stumped as I have not been able

I lost my bet with my cat who would claim this Kind regards Gerald On Sun, 12 Jun 2022 at 11:05, Tom

Hmmm, tfl are a law unto themselves... Yes, I've had many discussions about various emissions

Hi Mark, That's perfect. Thank you. Best Regards, Lisa On Friday, June 10, 2022 at 2:12:07 PM UTC

Hi All, I have a Mechatronika MR10 SMD oven up for grabs if anyone wants it. It works fine, although

Hi Myles I've sent you a direct message Regards Mark On Wed, 8 Jun 2022, 19:48 Myles V, <myles

Yes, all good. It's in the dropbox On Tue, 7 Jun 2022, 21:58 Najey Rifai, <najeyrifai@gmail.

Thank you Gavin, I could not agree more or write it better, so +1 thank you from me! Cheers, Alex

Hi all, I'm not sure how social media savvy us guys and gals are but I use Instagram quite a bit.

Maybe then use expanding polyurethane foam instead of concrete. With a lighter plywood spacer

Aye :) On Tuesday, 24 May 2022 at 21:31:05 UTC+1 hu...@crablab.co.uk wrote: Presume this discussion

Hey all, Alex already has dibs on some, please arrange with him for the remaining pieces. On Tuesday,

Hi All, I have a house, surrounded by a few (6?) meters of lawn, and then a simple gate to a footpath

Hi Tony I have been working on sketching a diagram using Fusion 360 and wondered if you are around at

Just a note to say that you can't cut tape/plastics on the laser cutter that contain Chlorine or

5:30 is fine. We can do the mitre saw too. On Sat, 28 May 2022, 22:34 echodelta10, <redparry1@

Yes we do, Rob kindly got us some a few days ago On Sat, 28 May 2022, 15:19 Mr E, <exchange101@

Chaps The repair Cafe last Sunday was a disaster. We had 2 of us doing electrical and general repairs

I am disposing of 5 x 29-volt recliner motors from a 3-piece suite. Does anyone have a use for them?