Starting OpenOTP RADIUS Bridge... Failed

[Jonatan Mc Evenue]

Hi. I Just did an upgrade of the OpenOTP RADIUS Bridge for v1.2.7 to v1.3.5. 

But afterwords the service will not start:

Checking system architecture... Ok

Checking server configuration... Ok

Starting OpenOTP RADIUS Bridge... Failed

I also tried a clean install be removeing the old installation and running the install again:

RCDevs OpenOTP RADIUS Bridge v1.3.5 Self Installer

Copyright (c) 2010-2018 RCDevs SA, All rights reserved.

Please report software installation issues to bu...@rcdevs.com.

Install OpenOTP RADIUS Bridge in '/opt/radiusd' (y/n)? y

Extracting files, please wait... Ok

Removing temporary files... Ok

Run OpenOTP RADIUS Bridge setup script now? (y/n)? y

Checking system architecture...Ok

Enter the server fully qualified host name (FQDN): 10.40.0.252

If WebADM is running on this server then press Enter.

Else enter one of your running WebADM server IP or hostname.

Note: You can use host:port if WebADM uses a custom HTTPS port.

Enter WebADM server IP or hostname: 10.40.0.252

Found one server URL: https://10.40.0.252:8443/openotp/

Retrieving WebADM CA certificate... Ok

The setup needs now to request a signed SSL server certificate.

This request should show up as pending in your WebADM interface and an administrator must acc

Waiting 5 minutes for approbation... Ok

Updating OpenOTP configuration file... Ok

Creating radiusd system user... Ok

Setting file permissions... Ok

Do you want OpenOTP RADIUS Bridge to be automatically started at boot (y/n)? y

Adding initd script... Ok

Do you want to register OpenOTP RADIUS Bridge logrotate script (y/n)? y

Adding logrotate script... Ok

OpenOTP RADIUS Bridge has successfully been setup.

Please read the README and INSTALL files in /opt/radiusd/.

root@DEB-OTP01:~# /opt/radiusd/bin/radiusd start

Checking system architecture... Ok

Checking server configuration... Ok

Starting OpenOTP RADIUS Bridge... Failed

I'm runnning an a 32bit debian installation.

Has anyone else seen this problem?

Thanks!

//Jonatan

[francois...@rcdevs.com]

Hi,

What is the format used in /opt/radiusd/conf/clients.conf? The old format does not work anymore.

It should be like this:

client my_client {
ipaddr = 1.2.3.4 
secret = testing123
}

[Jonatan Mc Evenue]

Hi Francois.

Thanks for that, i had missed that originally. Though i did do a fresh install without copying pver my client.conf settings. 

So i re-did a new installation and made sure not change anything,but it was till failing for some reason. I saw that there was a new version (v1.3.5-1) released. I gave that one a shot and it worked fine. So can't say what was happaning but it's all good now.

Thanks a lot for the help!

//Jonatan