powering Servo Extension Module
4 views
Skip to first unread message
Riccardo
Oct 28, 2010, 5:06:02 PM10/28/10
to RC servo interface
Hi Matt,
if I understood right the schematics, it should then possible to feed
high voltage servos (7.4V, 2 lipos), seen that it is insulated from
the rest of all the equipment. Am I right ?
It should be possible to feed the module with Vcc pin and a Gnd
somewhere, leaving RC rx insulated (if this make any sense).
Best regards,
Ric
if I understood right the schematics, it should then possible to feed
high voltage servos (7.4V, 2 lipos), seen that it is insulated from
the rest of all the equipment. Am I right ?
It should be possible to feed the module with Vcc pin and a Gnd
somewhere, leaving RC rx insulated (if this make any sense).
Best regards,
Ric
UAVflightdirector
Oct 29, 2010, 2:14:57 AM10/29/10
to RC servo interface
Correct. Servo output power is completely isolated from the receiver
power. That includes ground.
Vrx (servo positive volts) is isolated from Vcc. It can be conencted
through the holes marked PWR
The receiver ground is connected to the processor ground.
Yet another addition to the getting started docuement
Matt
power. That includes ground.
Vrx (servo positive volts) is isolated from Vcc. It can be conencted
through the holes marked PWR
The receiver ground is connected to the processor ground.
Yet another addition to the getting started docuement
Matt
Reply all
Reply to author
Forward
0 new messages