I finally got my OpenSprinkler all wired to power and to the valves. I've cabled Ethernet from the router to the OS. When I start the OS it says it's connecting to the network, but then it shows (button2 press) IP of 0.0.0.0 port 0. The router shows that the device MAC 00:69:69... is pulling an IP address with a TTL of 60 seconds over and over for several minutes, then it disappears from the router. To rule out my cabling, I plugged in a laptop to the same cable and it got an IP address just fine.
If I set a static IP on the OS, that address shows up on the router but then I can't load the OS web page using that IP address. After setting static IP, a button1 press shows the IP address I entered, and a button2 press shows the IP Gateway address.
Ideas?
Thanks,
--Mike