Re: [RAS_Prime] Abridged summary of rasprime@googlegroups.com - 9 updates in 2 topics

77 views
Skip to first unread message

john firth

unread,
Sep 28, 2025, 9:23:23 AMSep 28
to rasp...@googlegroups.com
the two HP 11s which I owned had the retracting Schreder hook;  side load increased the 
release force  to the point at which release was impossible; ie dangerous for novices .

dropping a tip on takeoff  could lead to an accident.

John firth

On Sat, Sep 27, 2025 at 8:52 PM <rasp...@googlegroups.com> wrote:
Tom Watson <ther...@gmail.com>: Sep 27 12:17AM -0400

John, Do you have room for a vertically polarized half wave dipole? Easy to build and you don't need a ground plane. Best, Tom W4APQ
 
Sent from my iPhone
 
On Sep 26, 2025, at 7:04 PM, John DeRosa ...more
Dave Nadler <d...@nadler.com>: Sep 27 11:11AM -0700

John, you didn't say - you did have the radio checked?
 
On Saturday, September 27, 2025 at 12:18:02 AM UTC-4 Tom Watson wrote:
 
...more
John DeRosa <jhde...@gmail.com>: Sep 27 12:03PM -0700

Dave,
 
Yes I did verify the radio. What I always start with in troubleshooting
radio problems is determining if the transceiver is the issue.
 
I checked the following;
 
> My club's fleet ...more
John DeRosa <jhde...@gmail.com>: Sep 27 12:18PM -0700

Thermaler,
 
That is a possibility. I assume that you are speaking of a center fed
antenna like this > https://www.cumulus-soaring.com/store/aae-vhf-5l.
Being 42" long It would need to be ...more
Tom Watson <ther...@gmail.com>: Sep 27 03:46PM -0400

John, Another thought is construct a 1/4wave Coaxial. You could probably get the radiator somewhat vertical in the back corner of the cockpit. The choke portion could just trail on the side or floor. ...more
Craig Funston <nimbu...@gmail.com>: Sep 27 01:20PM -0700

John,
 
I had a similar experience with the antenna in the rudder of my Nimbus 4. Measured SWR was horrible at first, even after replacing the coax from the rudder to the cockpit. I finally found ...more
Peter Hudson <peter...@gmail.com>: Sep 27 02:01PM -0700

I have a similar issue with my AC-4C...VSWR of about 2.9 and very poor
bandwidth and that's tuned at 135 Mhz...it's much worse at 123 MHz.  I'm
still thinking about a sort of laparoscopic surgery ...more
John Johnson <john...@gmail.com>: Sep 26 06:38PM -0700

*"My SCHREDER-designed glider had a persistent oleo strut pressure problem
that was fixed by replacing the strut's SCHRADER valve core" *
 
I see what you did there :-)
 
JJ
 
...more
Dave Nadler <d...@nadler.com>: Sep 27 11:10AM -0700

Jack, decades ago I had a glider with the Schreder retracting flush
tow-hook.
It had a nasty habit of premature release on very light back-pressure.
Likely a problem with my particular hook ...more
You received this digest because you're subscribed to updates for this group. You can change your settings on the group membership page.
To unsubscribe from this group and stop receiving emails from it send an email to rasprime+u...@googlegroups.com.
Reply all
Reply to author
Forward
0 new messages