Fibreglass antenna poles

[Mike Dunstan]

I appreciate this is very short notice but I will be placing an order with these people tomorrow and if anyone else would like to add to the order we can share the carriage charges:

https://engineered-composites.co.uk/service/grp-rods-and-tubes/

As an example, a 6 metre by 38mm tube is £38.40 and because of the length carriage is £52.75, all plus VAT.

If anyone's interested please contact me ASAP and I will add your request to the order. Delivery will be on Friday.

Regards

Mike G8GYW

[Mike Dunstan]

OK I just realised this was not such a smart suggestion as the tubes would be delivered to my house in Woodley and the other buyers would need to collect from there. 6 metres length would be challenging!

Mike G8GYW

[Mike Dunstan]

Anyone interested who lives reasonably close to me in Woodley please see kind offer below from Ace.

Don't delay though as I'm placing the order tomorrow.

Mike G8GYW

On 15 May 2023 18:00:12 Ace <a...@acestudios.co.uk> wrote:

Hi Mike,

If it helps, I could transport from yours to another club member if they were fairly local.

Best 73,

Ace

--
--
You received this message because you are subscribed to the Google
Groups "Reading and District Amateur Radio Group" group.
To post to this group, send email to rad...@googlegroups.com
 
To unsubscribe from this group, send email to
radarc+un...@googlegroups.com
 
For more options, visit this group at
http://groups.google.co.uk/group/radarc?hl=en-GB
---
You received this message because you are subscribed to the Google Groups "Reading and District Amateur Radio Group" group.
To unsubscribe from this group and stop receiving emails from it, send an email to radarc+un...@googlegroups.com.
To view this discussion on the web, visit https://groups.google.com/d/msgid/radarc/1881ffed758.27bf.fc4c1720f462fb886bf445d1bad5b019%40dunstan.uk.

[Mike Dunstan]

A few years ago I built a GPS disciplined 10MHz reference oscillator to the design published by the (sadly demised) Lars Walenius on eevblog:

https://www.eevblog.com/forum/projects/lars-diy-gpsdo-with-arduino-and-1ns-resolution-tic/?PHPSESSID=21sqjprduu9ps8ma0ddd35s20i

I built it on a PCB designed by PaulV and described here:

https://www.eevblog.com/forum/projects/lars-diy-gpsdo-with-arduino-and-1ns-resolution-tic/?PHPSESSID=21sqjprduu9ps8ma0ddd35s20i

I recently built a different design which I prefer so I'd like to offer this one to any member who has a use for it.

The GPS module has a genuine u-blox NEO-M8N receiver. The Vectron OCXO has seen better days but I have a couple of spares (Vectron and Blilely) which may - or may not - perform better. Plus documentation and schematics.

Anyone interested can collect from my QTH in Woodley and have a quick demo. Photos below.

---

Regards

Mike G8GYW

[Sergei M0TLN]

Hi.

If not taken I can do this weekend.

Cheers,

Sergei M0TLN