Groups
Groups
Sign in
Groups
Groups
R2C2 - Support
Conversations
Labels
FW
HW
Mechanics
Prusa
SW
About
Send feedback
Help
R2C2 - Support
1–6 of 182
Mark all as read
Report group
0 selected
César Araújo
, …
Rui Ribeiro
9
1/22/15
beep
Hi César, Look at this photo to see where to put the GND, RX and TX wires. Please note RX and TX is
unread,
FW
HW
SW
beep
Hi César, Look at this photo to see where to put the GND, RX and TX wires. Please note RX and TX is
1/22/15
César Araújo
, …
cesar....@g.xarevision.pt
3
10/23/14
Help
It was the motor piece that turns the pulley one screw was not tighten enough. Thanks Sexta-feira, 12
unread,
HW
Prusa
SW
Help
It was the motor piece that turns the pulley one screw was not tighten enough. Thanks Sexta-feira, 12
10/23/14
lionel...@gmail.com
8/27/14
Strange thing with skeinforge
Hi all, I started calibrating my reprap and I have a strange problem. When printing this part I end
unread,
SW
Strange thing with skeinforge
Hi all, I started calibrating my reprap and I have a strange problem. When printing this part I end
8/27/14
cesarsil...@gmail.com
, …
lionel...@gmail.com
5
8/30/14
Hello what i have found
Just tried with ABS, it does not work at all for me, unfortunately. However plastic sheet for books
unread,
SW
Hello what i have found
Just tried with ABS, it does not work at all for me, unfortunately. However plastic sheet for books
8/30/14
Albert Latham
, …
lionel...@gmail.com
9
8/27/14
Hotend not heating.
By the way, the thermistor lookup table can be updated without having to re-flash the firmware. For
unread,
FW
SW
Hotend not heating.
By the way, the thermistor lookup table can be updated without having to re-flash the firmware. For
8/27/14
repl...@gmail.com
2/7/13
Forward and Reverse = same direction
Hello, The forward and reverse buttons in the RepG control panel run the extruder in the same
unread,
FW
SW
Forward and Reverse = same direction
Hello, The forward and reverse buttons in the RepG control panel run the extruder in the same
2/7/13