Groups
Groups
Sign in
Groups
Groups
R2C2 - Support
Conversations
Labels
FW
HW
Mechanics
Prusa
SW
About
Send feedback
Help
R2C2 - Support
1–5 of 182
Mark all as read
Report group
0 selected
César Araújo
, …
Rui Ribeiro
9
1/22/15
beep
Hi César, Look at this photo to see where to put the GND, RX and TX wires. Please note RX and TX is
unread,
FW
HW
SW
beep
Hi César, Look at this photo to see where to put the GND, RX and TX wires. Please note RX and TX is
1/22/15
César Araújo
, …
cesar....@g.xarevision.pt
3
10/23/14
Help
It was the motor piece that turns the pulley one screw was not tighten enough. Thanks Sexta-feira, 12
unread,
HW
Prusa
SW
Help
It was the motor piece that turns the pulley one screw was not tighten enough. Thanks Sexta-feira, 12
10/23/14
cesarsil...@gmail.com
,
Nicolas Chaslot
3
2/14/14
heated bed
nice but... how do i dispose them im the sheet? do i need to have a glass on top? what mms ia thr
unread,
HW
Prusa
heated bed
nice but... how do i dispose them im the sheet? do i need to have a glass on top? what mms ia thr
2/14/14
rald...@mac.com
,
Jorge Pinto
2
4/24/13
Trouble reading the extruder thermistor.
2013/4/19 <rald...@mac.com> I added some debugging code to the firmware, and it reports ADC
unread,
FW
HW
Prusa
Trouble reading the extruder thermistor.
2013/4/19 <rald...@mac.com> I added some debugging code to the firmware, and it reports ADC
4/24/13
whoopy
, …
Chaslot Nicolas
5
9/10/12
help - the processor isn't booting any more
Hi everybody! today i wanted to try my first personal (no raft and full solid infill) profile for
unread,
HW
help - the processor isn't booting any more
Hi everybody! today i wanted to try my first personal (no raft and full solid infill) profile for
9/10/12