QZFM calibration process: B0 value and cal value

[Marc Jofre Cruanyes]

Hi,

I have a qzfm gen 2 inside a ZeroGauss magnetic shield (without degaussing yet).

After running calibration I get high values for B0 and cal value of 15.9 (as shown in the image below).

Is the B0 value normal? Is there any further test to check if the calibration is going ok or it is the shielding that it is not good enough?

Furthermore, if some times I get error in Cell T locked is there any diagnosis to run (I just started to tuse the device).

Best,

Marc