QZFM Discussion Board

Hi Ekaterina, A schematic was never made for this board, only the pcb layout files were made. I am

Please see: link Last updated:

Hi Sunny, The QZFM UI can only display the digital data for one axis at a time, at a set rate of 200

1. Is it possible to somehow configure the frequency range on the analog output at the hardware

What is resonance depth and what is its typical range for GEN-3 QUSpin?

Dear Oleg, That is correct, the range of the QZFM analog output is ±5 V which corresponds to a

Dear Sir/Madam, We are working on an experiment where we use a QZFM gen-2 coupled to a magnetic guide

Dear All, Inside a Zero Gauss Magnetic shield, I would like to introduce two small tubes which go

Hi, James, Got it. Thank you so much! Best wishes, Jing On Thursday, May 5, 2022 at 1:11:26 PM UTC-4

We have just posted an updated QZFM User Interface on the Quick Start Guide of our website here: http

Hi James, Thanks for the fast response. I made sure that the magnetomter is in master mode and I

Gen3 triaxial sensors have a serial number that starts with Z3T and Gen3 dual axis sensors start with

Dear all, I am using a QZFM Gen-2.0. Reading Gen 2.0 FAQS, it indicats that it has internal

Hello Dom, We use the LabView Spectral Measurements Express VI to calculate the power spectral

Hi, I have a qzfm gen 2 inside a ZeroGauss magnetic shield (without degaussing yet). After running

Thanks James for the fast reply and information. I managed to make it work with the indication

Hi Marc Jofre, We expect that there is no mechanism for interaction between the QZFM operation/output

Could you please provide the third dimension of Electronics Module? There are only two of them in the

Once during data processing we noticed that signal from J1 mirrored to J9, from J2 mirrored to J10

We have a laser problem with some of our Gen1.0 sensors, since we see 'Retrying laser lock'

The calibration number of one our Gen1.0 sensor was initially a bit higher than the calibration

To clarify we would not expect cross-talk to cause an issue like this at all. LED2 is the cell

APOLOGIES! replied in error, I thought it was aq addressed to me best On Wed, Aug 19, 2020 at 11:02

We have not seen this vibration/motion noise with the Gen1.0 cables to the same extent as with Gen2.0

The heater frequency beat notes can occur at essentially any frequency depending on what they are

Thank you very much! We will try to design the UI. On Wednesday, March 11, 2020 at 7:09:01 PM UTC+8,

It sounds like Print may not have been turned on before starting the data save. Ensuring that the

This version of user interface does not support recording of digital data. The current release of the

The computer requirements are a 64-bit computer with Windows 7 or later. When using the QZFM-UI-v3.2

Cables should not need to be reconnected unless the computer is not communicating with the

Unfortunately neither QZFM or QTFM is designed for operation in the kHz/MHz region. In theory, the

The QZFM sensor can operate continuously for extended periods as long as the sensor is well