Missing sys-USB, Reinstall?

[Ray Joseph]

I have recently install V4 on a laptop. I noticed there is no sys-USB.

What is the appropriate method to produce one?

I currently have no network connection either. The newly installed system had sys-net attached with the two USB controllers and no nic. So I removed the two USB controllers and added the nic. The vm no longer errors out when booted.

I am concerned there may be more problems I have not seen yet. This is a new install; is there something I did wrong that would have caused these error? I am going on two weeks trying to fix what I have.

Should I just attempt to reinstall? I don't know what I should do differently.

Any suggestions?

[awokd]

Ray Joseph wrote on 4/5/19 4:30 PM:

> I have recently install V4 on a laptop. I noticed there is no sys-USB.
>
> What is the appropriate method to produce one?

"sudo qubesctl state.sls qvm.sys-usb", but see
https://www.qubes-os.org/doc/usb-qubes/ .

> I currently have no network connection either. The newly installed system had sys-net attached with the two USB controllers and no nic. So I removed the two USB controllers and added the nic. The vm no longer errors out when booted.

Let's continue troubleshooting that in your other thread.

> I am concerned there may be more problems I have not seen yet. This is a new install; is there something I did wrong that would have caused these error? I am going on two weeks trying to fix what I have.

Nothing wrong; you may have checked the box that says to combine USB and
Network into the same qube.

> Should I just attempt to reinstall? I don't know what I should do differently.

No, the steps you've already done and the command above will cover it.