Quantum Owners Group

Our thanks to everyone that replied with helpful information. We bought a slave cylinder for a 1.1

Thanks folks, Seems like I should try and get it altered next year. My 2+2 was SVA'ed and has the

Hi There is a join between the top and bottom half along the sill line which is foam filled, we

Hi When weather allows, I will investigate. But what can I jack and observe? The suspected failure is

Attached wiring pic is from Saloon MK2 build manual - 2+2 should be same I think. My saloon has

The Quantum Owners Club have been accepted for a stand at the 2024 Silverstone Festival. More

Thanks Jim & Darren for suggestions. EFI flywheel and standard Ford crank sensor is an option but

David has the pictures on the owners club facebook page if you are a member of that. https://www.

Adjusting tickover was easier than I was expecting, started ,screwed out adjuster 1 turn, let it idle

Any standard shoulder bolt the right size will do for balljoint also. As other have said a higher

The temp pump seems to be working fine and the line once again not clear... like i said its sender

To be quite frank I am starting to think of making my own mount design and getting it made with

No rattle on mine. I can see the face of what looks like ball bearing but cannot move it backwards.

I did use the extension method in one config - I used standard XR2 hoses together with inline temp

Hi Martin, well spotted, it is in fact a saloon not a 2+2. Thanks for the correction. On Tue, 25 Jul

Excellent, thanks all for those very useful responses. I shall report back once I've decided what

I have replaced all my standard bulbs on 2+2 with modern equivalents and passed MoT for several years

My Q2+2 was registered as brand-new in 1997, by Old Quantum in Stourbridge, and used as the factory

I telephoned Grosvenor Exhibitions today to pre-book my ticket for Newark 2023. Unlike last year,

Just putting this post up to thank the committee and the Club for presenting Hilary and me with this

Club members can log into the QOC website to see information about the QOC AGM to be held on 03 June

It can be done with one but once you release one side you need to keep a gentle pressure and tilt on

Current front lights setup on my saloon is spots in the spoiler (wired to only come on with main beam

After much searching I've only found a 2 hose silicone kit for £148 + p&p. or full kit for

Re Camshaft etc. : A agree with Jim's comments that all the performance cam suppliers usually

Hi Mick Re: Oil Leak - I had a leak which initially I thought was coming from rear seal area. I dried

Just been catching up on your various posts ... Welcome to Quantum saloon ownership - sounds like you

New mount was pretty easy to fab up thankfully although I added the original ford nut by accident

I tried a local radiator recon place and low and behold he pulled a old stock ford radiator out of

Yes, that's normal. Some people weld the nut onto a steel plate then bond that plate onto the