no or zero simulated flows at outlet channel

[Eskinder Zinabu Belachew]

SWAT+ Issue Report Template

1. Primary Issue Location

Component: SWAT+ Editor Area of impact: Model output (runoff simulation)

2. Software Versions

GIS Interface: SWAT+ Editor v3.2.4

3. Project Characteristics

Watershed Details: 6090.77 ha Modeling Aim: Water balance, ET, flow, water quality

4. Description of Issue

The Problem: After running the model in SWAT+ Editor (v3.2.4), the simulated flows values are consistently zero. To confirm, I checked the automatic calibration chart in the SWAT+ Toolbox, and it also shows simulated flow as zero, while the observed flow is displayed properly.

Steps to Reproduce:

• Load project in SWAT+ Editor v3.2.4

• Run simulation

• Export txtinout to SWAT+ Toolbox

• Open automatic calibration chart

• Observed flow appears correctly, but simulated flow remains zero

Request: Could you please advise on possible causes of this issue and recommend steps to resolve it?

[Nancy B. Sammons]

Eskinder: 

Send me your current txinout folder and I will take a look.

Thanks,

Nancy

--
You received this message because you are subscribed to the Google Groups "QSWAT+" group.
To unsubscribe from this group and stop receiving emails from it, send an email to qswatplus+...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/qswatplus/b5309886-97ae-4dff-aa0d-0ca7eb4f1bdfn%40googlegroups.com.