Tp_link
Pamula Harrison
This code was made in Python to interact with the tp_link 840n router firmware
Firmware Version:0.9.1 4.16 v01e4.0 Build 180709 Rel.56645n.
This is a part of the code that I have already tested but when changing the password it gives me the aforementioned error
Hello,
Yesterday I installed the openwrt firmware ( openwrt-ramips-mt7620-tplink_c2-v1-squashfs-factory.bin) to my tp_link ARCHER C2 V1. I did this with the old firmware, upgrade fonction. All was ok until I reboot. After the reboot, the leds flash slowly but I can not connect to the device. I tried 192.168.1.0 and 192.168.1.1.
I tried to go back to factory firmware by pressing ( 30secondes) the reset button, but it seem not working!
Any ideas?
Thank you.
Since you did an upgrade from previous OEM firmware, have you verified that after the reboot your devices are connected and acquire the IP/mask/Gateway/DNS settings from Openwrt?
Sometimes if the DHCP lease time is long, devices might not request for an updated IP after the new firmware is installed for some time, remaining with the old settings, which will probably not work.
Development builds / snapshots The development branch can contain experimental code that is under active development and should not be used for production environments. Snapshot images may support additional hardware; however, it is experimental,...
LuCI essentials This article relies on the following: * Accessing web interface / command-line interface * Managing configs / packages / services / logs Introduction While OpenWrt can be managed completely using SSH and the terminal, the LuCI...
This evening, after work (France time), I decided to give alast chance to my router:smiley:.
I downloaded TFTPD32 and I applied the recovery method described on this page: -link/archer_c2_ac750
After several tests it worked (I dont know why). The firmware was loaded into the router in about 15 seconds. I do not remember if the router started again alone or if I did an on/off.
Now, when I switch on the rooter, the power led stay on and another led bright two secondes and goes out. But I can not access the router with 192.168.0.1 or 192.168.1.1
I tried to flash the recovery firmware again, with the same method, with TFTPD32 but but despite many tests it never worked.
Is there something to do? Is there a better soft than TFTPD32?