PrivateEyePi

hi ok taken another look at the globals.py and have changed the second sensor to a non exsistant gpio

I truly thank you for all of your community support. I will test that new repository, On Friday,

Can you elaborate? On Fri, Feb 7, 2020 at 3:20 AM Ilham Tantowi <ilha...@mahasiswa.pcr.ac.id>

You might need to try a lower resistance resistor. If you have a lot of wire running to all your

That error means some other process was using the serial port. Sounds like multiple apps are

Thank you. I will try that. Den söndag 12 februari 2017 kl. 21:26:47 UTC+1 skrev Leslie Holm: Hello

Hi Edit the dallas.py script #Main Loop while True: if (elapsed_temperature_time > 600):

Need more information on your wiring. Sounds like a wavering GPIO caused by insufficient pull up but

Please check if your password has special characters in it. If so go onto the website and change the

I mounted a HiRes webcam in a cheap dummy dome camera housing to mount as a surveillance camera

Looks like you're missing the /var/run/motion directory. Try this: sudo mkdir /var/run/motion/

Yes, The best sensor is to use a 10 k thermistor. Or use this sensor: http://ha.privateeyepi.com/

NumRF not defined means you don't have any sensors to Type 'RFSENSOR' or 'Temperature

Hi, For the 4 button remote you use the normal alarm.py script. Set it up like a door switch, and

Want to make your alarm system really compact? Check out this PrivateEyePi shield: It is a two sided