Re: Gigabyte Windows Usb Installation Tool Windows 10 Descargar
Montana Strobl
Have my first issue with my very first build after using computers and remembering the days before the interweb. I intended to be ambitious and to maybe over build with some headroom for future upgrades. Whatever I own I do try to ensure I get the best out of it and to that end I am bumping against installing Win10 after Raid 0 the two drives within the Bios. I have gone through the videos of trying to load bottom drivers then raid config but i still get get the windows setup to see them as raided drives. I need a detailed idiots guide rather than a detailed expert guide if that makes sense. Any help with videos or pdf's......at 43 I am feel it might be like teaching someone to use a spoon. Will continue my own searching and googling as there must be something I am missing.
3.Enter the Raidxpert2 menu in BIOS, you need to initialise (writes some data to the drives to prepare them for Raid) all hard drives that will be used for Raid. This option will be in the Raidxpert2 menu, so check all options.
I try raid 0. In bios I'm creating raid, and at first glance everything is fine (I can add screenshots from the BIOS). Then I made a bootable USB flash drive and added drivers there. During installation, I add 3 drivers sequentially from the DD folder, they are installed, but still two nvme disks are displayed.
Strange thing. tried again from the beginning. In the BIOS, I left SATA in AHCI mode (before that stood in raid), and nvme as raid. I got to the driver installation and this time I could not install anything from the nvme_did folder, the list was empty, like "incompatible with my equipment". But from the nvme_cc folder (for a different processor) - success, and one disk appeared! While everything seems to be established and working, I observe.
I used the NVMe_DID drivers, browsing to and then installing rcBootom, RCRaid, and RCfg in that order. It made no difference - after installing all three drivers and doing a refresh, the Windows installer still sees two separate NVM drives and can't install.
However, from reading AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems I've seen that this can happen when the system has multiple controllers, so no problem - I choose the first one.
Yes, drivers will be provided and added to that page when they become available. For now you can use the previous drivers for Windows 11. I am using them on my Windows 11 installation with 2 drives in Raid 1 configuration.