You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pocket NC
Hello every one, I am trying to change the units to mm from inch but even after i change the settings from "Config->Display->mm" that changes only the DRO readings. If i was to do a G00 code it would move in inches rather than in mm.
ke...@pocketnc.com
unread,
Jan 28, 2019, 10:46:51 AM1/28/19
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pocket NC
Hi Salman,
You'll want to check that you have the latest software for the V2. You can find these instructions here. Earlier versions did have a bug where the metric units didn't carry over to the DRO.
Thanks, Kerry
joum...@yahoo.com
unread,
Mar 25, 2019, 6:25:38 AM3/25/19
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message