Won't go to X=0 and Y = 0

[Daniel Jackson]

Hi guys and gals,

My machine when I tell it G0 X0 goes to X=.8 mm and Y = 1.1 mm. When I did a cut that involved the tool moving in a circle it was off center by this amount also. Anyone have any solutions to this?

Daniel

[qrot...@pocketnc.com]

Hi Daniel,

I am still looking into this, thank you for your patience. Be on the lookout for an email from me sometime today. 

Thanks!

Q Rothing

[qrot...@pocketnc.com]

For those of you following this thread, the issue Daniel was running into was a Z offset that was still saved in the machine, causing the machine to return and move to the wrong position. The easiest way to clear those unwanted offsets is to shut the machine down and disconnect everything. Then, after letting the machine sit for 30 seconds to a minute, reconnect and power on. 

Happy Making!

Q Rothing

Applications Engineer, Pocket NC