You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pocket NC
Was cutting my first aluminum part. Stop at the middle of job. Restarted and was not homing at all. After cleaning started working again. This time the spindle is running much slower and with no force...
Tokyo Pav
unread,
Dec 11, 2018, 12:53:03 AM12/11/18
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pocket NC
Hi Gonzalo
There was a guy on twitter who had the same problem. He took the end cap of the spindle motor and had to tighten a screw or two. It resolved the slow and no power issue with the spindle.
Regards
TP
ke...@pocketnc.com
unread,
Dec 11, 2018, 9:57:40 AM12/11/18
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pocket NC
That was in fact the issue - just had to adjust the hall sensor at the back of the spindle motor.