Plastimatch DRR energy level

Skip to first unread message

Daisy S

Feb 25, 2023, 9:49:30 AMFeb 25
to Plastimatch

Could you give any information about the energy level when using DRR generator? And Can we choose the values at command line?

Thank you so much!


Sharp, Gregory C.

Feb 27, 2023, 3:54:46 PMFeb 27
to Plastimatch
Hi Daisy,
The default is 50 keV mono-energetic (from NIST). I'm afraid it is not easily adjustable.

From: <> on behalf of Daisy S <>
Sent: Saturday, February 25, 2023 9:49 AM
To: Plastimatch
Subject: [Plastimatch] Plastimatch DRR energy level

External Email - Use Caution
You received this message because you are subscribed to the Google Groups "Plastimatch" group.
To unsubscribe from this group and stop receiving emails from it, send an email to<>.
To view this discussion on the web visit<>.
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at <> .
Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.

Reply all
Reply to author
0 new messages