PIK20

This is a well known link. Very much of the blueprints and the manuals are there for free download.

During a flight in wave/rotor , I hit the wildest rotor in 50 years of wave flying. There was no

The pik20D leg indeed relies on locking by the fascia detention in the cockpit. When locked like this

ive been using lps3

Does anyone know the diameter of the Fokker pin for the main bolt of the Pik20 a/b?

Looking to buy undamaged gear assy for a PIK 20e; does the D model use the same structure? John Firth

You may use any cerified epoxy. Eg epikote L20 or L285. Depending on the hardener different cure time

Mine has something similar to this, glued onto the side... https://www.aircraftspruce.com/catalog/

Dear PIK friends, Recently, I was suffering from release difficulties. The suspected cause is the

Perfect, this is exactly what I needed. Thanks a lot! Janos On Thu, Jul 10, 2025 at 10:10 AM Narre

Not originally fitted with 5 point harness From: pi...@googlegroups.com <pi...@googlegroups.com

I recently had the opposite issue on my D; I struggled to lock them once open. My inspector and I

Hi, I have also discussed with Scott. I have one 20A canopy, it is available. Just need to see the

I have an issue with my 20D. the paint is peeling from the leading and trailing edges of the wings.

this technique may be known to many repairers, but I had not heard of it. recent repair of upper skin

I use MGS 285 for most structural work. MGS may work too, but has a lower glass transition temp.

https://www.aircraftspruce.com/catalog/pdf/mgs285tech.pdf Yahoo Mail: busca, organiza, toma el

Have a look at: https://www.dg-aviation.de/en/library/emergency-bail-out Nice and safe flights!

Tach working normally last Oct; Airleak found and fixed but now the tach does not read. the circuit

Most just use a white lithium grease. In most cases it works great, is cheap and easy to use.

what grease do you guys in america put onto the wing pins and the main thru spar pin? something easy

Here is the trailer restraint that was installed on my PIK20E trailer. Ratchet straps are nice, but

hi guys my IA doesnt much like the original PIK20 seat belts...due to the PIK.being a certified

Air leak; despite efforts to seal exit fitting, still exists. at tank exit tapr thread fitting? at

Hi all aging PIK pilots, the 20 E has always been difficult to exit; even with the pedals fully

Hi, Thanks! Riku From: Janos Bauer <bauerj...@gmail.com> Sent: Monday, May 12, 2025 8:22 PM

After reinstalling the tank in april, the engine would not run without choke. Investigation showed a

Keith, I'm mot sure if there is an "Automotive Equivalent". The original shocks were, I

There should be a spring (markd red below) that pulls the support beam down and holds the pin at 4 in

Hi, I'd like to be added to the PIK WhatsApp group. I am the owner of a PIK20B VH-WQF. Regards

Hi, On mine it was the cable down to the wheel brake if I remember correctly. Sent from my iPhone On