B3 Innovations - Pico Support

Hi Willem, I responded to the thread you opened here: https://groups.google.com/d/msg/pico-support/

j.contr...@gmail.com, can you share your slicer settings?

I'm communicating with them now about getting their HPX1 to use with Pico. I'd also like to

so you had to make a fan shroud similar to what e3d does with their hotend that might explain the new

Hi, Best print to date. Wish I'd known about the bore before! :) Cheers, Nick

There was in fact a loose connection with wiring to the hotend. working ok now!

I had the same problem - turns out the fan for the heat break was leaking enough air to keep the hot

Hooker J, Thank you for this. At first we thought you are having issues with jamming but it seems

Hooker J We are sorry you feel that way. We will do what it takes to remedy the situation. I checked

One way to avoid this, which I've used,is to hold the thermistor and before the hotend is mounted

So from what I can see there is some math that can be done to establish the 3.3v adc values from the

That is a good point, all the resistance measurements were based using an Arduino Mega so the 5v ADC

So if you are looking at a Marlin based temp table anyway, the values are based on an ADC reading. If

Just re-designed my Pico cooling setup for my Series 1: http://www.thingiverse.com/thing:1477168

When you guys get the new site up and going, are you going to still have nozzles available for V1?

Actually I think I may have figured out what my problem was. I share it here so perhaps someone else

I just picked up a Pico and am trying to get it to mate with my MK8 extruder, through an aluminum

I am interested in getting a buying a backup 1.75mm 24V Pico, as my old one has been through a lot. I

Hi, Thank you for posting up on here and thank you for backing us! We really appreciate that! We are

Kris, We will definitely get those to you. Shoot us an email at he...@b3innovations.com and we can

Hi, Intriguing design. To answer your question, the MK 8 nozzles are not compatible with Pico. The

Thank you very much for sharing your positive feedback and experiences with Pico! We like to print on

Hi, Please email us your shipping address to: he...@b3innovations.com and we will reply with an

I will respond with instructions on this in the other topic thread shortly. Link just in case: https:

You could likely take a multimeter to the existing heater element and read the voltage to sort out if

Hi, The choice between heaters is determined by what your printer or electronics board on your

I'm sorry to hear about this, it sounds like the stem got stressed and developed a crack. Do you

Jh, Take a look at this thread and my response below it. Hope there is some helpful insight.... https

Trying to get more heat out of a Flash Forge Creator Pro any ideas??? also no sure of the Watts

Hi Have you test to print any filaments up to 450C ? PEEK for example. Hugo

Mike, Sunday evening I ran across the following forum post which indicated that the XYZ Da Vinic 1.0

Thank you. They look great. I ordered a pair.

It seems my original post did not make it through a while back so I am re-posting: We put up not too