You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pi4J
Hi! I would like to know if could I change the default values to read the MCP3008's signals from any GPIO's pin? Regards
Andrew Chandler
unread,
Oct 31, 2016, 8:40:45 AM10/31/16
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pi4J
I believe of it remember right the mcp3008 is an spi chip meaning it needs to get connected to the spirit bus on the picture.
Steve Kim
unread,
Nov 1, 2016, 12:51:00 PM11/1/16
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to Pi4J
Type "SPI interface daisy chain" in the Google search engine. This search will show how to hook up multiple SPI devices. And get the pin schematic of Raspberry Pi to find where are the SPI pins