Pearson 422 Owners Discussion Forum

Hi all, I was recently informed that the store was no longer working. Sorry about that!! I made a new

Sorry for the first post, I am not familiar with Google Groups. I would love to speak with anyone who

Hello, I recently acquired a 422 and would like to be able to post to the forum. Can you please let

Are there any 422 owners near clearwater florida that would be willing to let me look at their boat?

Hi Everyone, As fall approaches I'm getting ready to pull my 422 out of the water and have

Hi Lee. Thank you for your input. Here is another picture. Water always finds the lowest point to

Thank you Greg, appreciate the response. Alan On Friday, October 26, 2018 at 8:32:50 AM UTC-4, Greg

I remember him saying it was bronze and he had a new one machine. Is your boat out of the water? On

I remember him saying it was bronze and he had a new one machine. Is your boat out of the water? On

Eric, if ya would like to see one in person our 422 is in Sam Fransisco at pier 39. Welcome to. Come

I am looking for pictures of how people have their stay sails setup. Do you have it setup as self

Phil, Thanks for the input. I had a rigger check the system because we are having problems with it..

Can you post pictures?

Thanks, Lee. Sounds like there's hope - as long as the cables are wire-tied together as a single

Anybody successfully replace the VHF coax in the masts with the mast up? We are planning to cut off

Just checking to see if anyone has original staysail rigging configuration in tact and maybe you

Yes we did. It sold in 10 days -----Original Message----- From: Captain Verena <captain.verena@

We have. We installed a Schaefer traveler system. http://www.atlanticriggingsupply.com/sc11brtrsyco.

Under the companion way. -----Original Message----- From: Gary Soward <gjso...@gmail.com> To:

It Is also in a soundproof box.. 2 years ago our exhaust elbow went out. After we pulled it out to

We have a 5KW in the starboard locker/generator room across from the breaker panel.

We installed a drain plug in the extreme bottom of the boat. We then used a hot water power washer to

Did you get the answer to this question?

Hey Capn, There a lot easier way to do that. After disconnecting the engine from the trans and

I took my W58 out to rebuild it. Therefore, I had to move it foreward into the salon rather than aft

I'll be back to the boat in about 3 weeks. I'll take an accurate measurement of the anchor

Hi, I own hull 38. My holding tanks are two bladders set in the bilge areas. I think the boat with

We had hull 22 for 10 years and the deep sump was right below the transmission like the last poster

Gary, Thanks for the info. I will call them tomorrow. I have the boat in The Bahamas and am getting

Click on this link. http://newyork.craigslist.org/jsy/boa/4980978008.html

The original tanks were supplied by Florida Tanks. They still have the original designs and can make