Iso 1328-1 Pdf

[Phuong Fulsom]

SCOPEThis part of ISO 1328 establishes a tolerance classification system relevant to manufacturing and conformity assessment of tooth flanks of individual cylindrical involute gears. It specifies definitions for gear flank tolerance terms, the structure of the flank tolerance class system, and allowable values.

This part of ISO 1328 provides the gear manufacturer and the gear buyer with a mutually advantageous reference for uniform tolerances. Eleven flank tolerance classes are defined, numbered 1 to 11, in order of increasing tolerance. Formulae for tolerances are provided in 5.3. These tolerances are applicable to the following ranges:

FOREWORD

[The foreword, footnotes and annexes, if any, in this document are provided for informational purposes only and are not to be construed as a part of ANSI/AGMA ISO 1328-1-B14, Cylindrical Gears - ISO System of Flank Tolerance Classification - Part 1: Definitions and Allowable Values of Deviations Relevant to Flanks of Gear Teeth.]

The Gear Classification Manual, originally published as AGMA 390.01 in 1961 and revised as AGMA 390.02 in September 1964, provided tolerances for gear tooth flanks. AGMA 390.03, published in 1973, was a major revision that consolidated the information in AGMA 390.02 with several other AGMA publications, including:

ANSI/AGMA 2000-A88, Gear Classification and Inspection Handbook - Tolerances and Measuring Methods for Unassembled Spur and Helical Gears, was an update of those sections from AGMA 390.03 for parallel axis gears only. Additionally, the formulas stated the tolerances in both U.S. standard and metric terms. The content was revised, but basic tolerance levels were unchanged from AGMA 390.03. The other material in AGMA 390.03 on bevels and worms was replaced by ANSI/AGMA 2009-A99 and ANSI/AGMA 2011-A98, respectively. ANSI/AGMA 2000 was approved by AGMA membership in January 1988, and as an American National Standard Institute (ANSI) standard on March 31, 1988.

ANSI/AGMA ISO 1328-1 was developed by ISO Technical Committee 60 as an International Standard with ANSI/AGMA participation. It was first published in February 1995, was adopted without changes by the AGMA membership in June 1999, and was approved as an American National Standard in November 1999. While the subjects covered in this standard were similar to those in ANSI/AGMA 2000-A88, there were significant differences. They included:

ANSI/AGMA 2015-1-A01 later replaced ANSI/AGMA 2000-A88 and ANSI/AGMA ISO 1328-1. It combined the grading system of ISO 1328-1 with the methods of ANSI/AGMA 2000-A88, and added concepts of accuracy grade grouping for minimum measurement requirements, filtering, data density, and roughness limits to form deviations. Tolerance formulas were based on the actual gear geometry rather than on geometric mean values.

NORMATIVE REFERENCES

The following documents, in whole or in part, are normatively referenced in this document and are indispensable to its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.

ISO 1328-1:2013 establishes a tolerance classification system relevant to manufacturing and conformity assessment of tooth flanks of individual cylindrical involute gears. It specifies definitions for gear flank tolerance terms, the structure of the flank tolerance class system, and allowable values.ISO 1328-1:2013 provides the gear manufacturer and the gear buyer with a mutually advantageous reference for uniform tolerances.

3a8082e126