OPNET 16 and Zigbee Link Model Designation when using Rapid Configuration

[mw]

While trying to set up a Zigbee network in Opnet 16 Modeler, I
discovered a problem.

While using the rapid configuration option under topology, the model
parameters always ask for a link model. The only problem is that there
is no link model listed under the drop down.

If I try to create a link, the only supported types seem to be for a
wired network, and there are no sorts of links on the zigbee palette.

If there is no link selected, then it is impossible to progress with
the setup.

Does anyone have any information on this problem.

Any help would be appreciated.

[Madhu Vinod Diwakar]

hey even I had the same problem. Did you get the solution for that?
Thank you in advance...

[itexpertnz]

I am facing the same problems is here in OPNET 16. I think to do this
just need to add node model somewhere in OPNET directory, bcoz given
model shown in that option is retrieving from any folder. I am trying
If I got solution then hopefully will share it.

On Jul 21, 8:38 am, Madhu Vinod Diwakar <madhuvino...@gmail.com>
wrote:

> > Any help would be appreciated.- Hide quoted text -
>
> - Show quoted text -

[programmer]

can u plz send me the link of opnet 16 ...

 

[linda paul]

Hi

so you can see the Zigbee nodes under the drop down menu?!!

 

I'm using Opnet modeler 15.

 

Please tell me how to have rapid configuration for zigbee nodes at well.

Thanks a lot.