You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to OpenVSP
Is there any way to remove the concave part of this model both cross-sections are at the same width and i turned off skinning to allow a linear taper? any help would be appreciated!!
Rob McDonald
unread,
Apr 14, 2024, 4:03:32 PMApr 14
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to OpenVSP
Can you post the *.vsp3 file?
It looks like you've messed with the paramater speed. Are these rounded rectangles (the key corner button should be selected the same universally) or are they CEDIT cross sections (did you play with the parameter speed?)
Rob
Henry Boot
unread,
Apr 14, 2024, 6:01:12 PMApr 14
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to OpenVSP
In the photo it was a rounded rectangle transitioning to a CEDIT composite cross-section with a rectangle and semi-circle on top. I changed the rounded rectangle to a super ellipse with similar properties and it is still there. I am not sure on what the parameter speed is exactly checking the forum is it the variable "U" ? any advice is appreciated thank you Rob!!!