You do not have permission to delete messages in this group
Copy link
Report message
Sign in to report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to openSCADA
Hi everyone
I want to configure the ESCM file to do some HMI job.
At first, I configure the ESIM file to connect to Modbus simulator like below:
Then, the ESCM file is configured as following:
but unfortunately, in the ostc, I cannot see the changing value from master server.
Is there anything wrong with the ESCM configuration?
Thanks very much!
CptMauli
unread,
Jul 6, 2016, 8:34:46 AM7/6/16
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Sign in to report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to openSCADA
In general it looks good. But I think the problem is in the "Source Name" of the External Value. I think it must be called modbus.data.S1.B1.V1 (instead of S1.B1.V1 only)
Jürgen
Frank Z
unread,
Jul 7, 2016, 11:26:49 PM7/7/16
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Sign in to report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to openSCADA
Thank you very much, Jürgen.
it works.
"modbus.data.S1.B1.V1 " is the right "Source Name"!