The OpenRC Project

Hi guys, I'm new to 3D printing, how do I decide which 3D printer to buy? Please advise, thanks

is there another place with a more active open rc community? or am i just late to the party?

I interesed on this post... The shaft are very cheaper On Friday, May 1, 2015 at 10:06:44 PM UTC+2,

Hi Folks I was just made aware of this group by someone who commented on my instructable. I have just

Thank you for the reference! I am going to order some of these parts soon and start the build. On

Yes. I had to adjust the build plate size in Simplify 3D because it was slightly smaller than the

I'm stuck at the same point. There are a million different driveshaft configurations for 1/10

I am starting a new online community called Creator Kits. The inspiration for Creator Kits came from

A LiPo compatible ESC will say in the specifications "2S Lipo minimum, 3S LiPo maximum" or

ive tried to find a nice drawing of a fricton clutch to copy, but not had any luck. Agreed it may not

Sorry no help on specific lengths but I just made a post about this. I salvaged some 3mm stainless

First some backstory I have been playing with adding a laser cutter to my 3d printer. To start I took

Hi guys I done the following. All the bulky chassi parts I printed in PLA, as well ad parts like

I have ordered printing of small gears frim shapeways. Will report when I get them. Regards Boris On

I am planning on using XT-Polyester for all the moving parts since it is stronger than PLA. For all

I am too in the process of printing. Have you tried this spoiler and is it working good ? On

Hello, congratulations on the OpenRC, it's very very good. I have one question, I'm looking

Here's my version on the proper way to convert a stock 2wd Slash to a Mid-Engine LCG Slash! https

Hello! I am new over here. I am going to build myself a truggy. I want to know which technology does

:Hello, I have motor, ESC, servo, wheels, shocks, battery, battery Charger, radio and all the the

Hi, Can you tell me what ball ends are used for steering, Hobbyking, ebay...?. Thanks!

I've started one here (https://github.com/bryancostanich/OpenRC/blob/master/Truggy/BOM.md) along

Daniel Noree has hosted the designs on : https://grabcad.com/library/openrc-1-10-3d-printable-rc-

what is the pins size on the A arm and where do did you source yours?

Whoops lol. I was looking at industrial supply websites like mcmaster carr were they wanted 7 dollars

Ok, I will do that. No problem :-)

I calculate the module of the central wheel, and I found 36dp. Is it ok ? How many teeth should I

100mm for both front and rear ? Thanks ;-)

Hi, I can assemble my first differential printed PLA soon. Should I lubricate it during installation?

Posted on the Thingiverse page: Thanks for the STP-file. I counted all the crews and came up with the