Two questions regarding event based calculation mode

[Sebastian Carrascal]

Good morning,

I'm about to start an important number of hazard calculations of municipalities in a department of Colombia. I would like to have a unique rupture catalog for a whole region so that I could sum different exceedance curves—even though event_based_risk runs individually for every municipality.

1. I would thank you if you could share the guidance to run a rupture catalog of a bigger region and then compute hazard separately for specific sites.

2. Some time ago, I'd seen there was the intention to make it possible to run GMF in the same location with different site conditions. I would like to apply this too. So I hope you can share the git hub site or discussion as well.

Best regards.